Everyone knows that the sex dolls on the market are mainly silicone and TPE dolls. Many mid-end consumers mainly buy dolls with silicone heads and TPE bodies, or there are users who buy all-silicone sex dolls. The way of cleaning up sex dolls with different materials is different.
Silica gel is a kind of thermosetting elastomer. It has the advantages of safety and non-toxicity. It does not decompose water and any solvents. It is non-toxic and tasteless. It has stable chemical properties. It does not react with any substances except strong alkalis and hydrofluoric acid. It has high adsorption performance and heat Good stability, stable chemical properties, widely used in adult products and food products.
1、Compared with TPE sex doll, silicone sex doll requires maintenance and does not require conventional oil treatment.
2、To avoid this, please use a large "powdered makeup brush" to powder her skin with baby powder/cornstarch or corn flour.
3、Caution: Even if you have a silicone doll, the skin of the doll will leak oil after being stored in a stack.
Pay attention to the different materials of dye and ink, as they will transfer the color to the skin of the doll. Avoid the following items: newspapers, dark or leather materials and surfaces (leather sofas, leather wheelchairs) or other materials containing oil-soluble pigments.
Before putting on new clothes for the doll, it is very important to wash it in advance to avoid silicone. Black tights are particularly easy to correct and should be left on the girl very carefully.
When you wear new clothes for the first time, check regularly for stains. If the clothes have changed, please take them off and wash them in a higher temperature washing machine to remove the dye.
If your doll gets shorter, take some time to let the dye fade, the discoloration will disappear on its own within a few weeks.
Every time you use it in the bedroom, shower or bathroom, you should thoroughly clean the holes of the sex doll with mild antibacterial soap.
Xinnuo factory recommends using "Dettol Disinfectant" soap to clean and disinfect the orifice plates. A link to Dettol soap on Amazon.com is provided at the top of this guide.
To clean the doll’s mouth, it is recommended to remove the head from the doll and then lift it to the shower. Then, remove the nozzle nozzle, and use concentrated electric current to flush the inside of her mouth.
After rinsing your mouth, scrub with soap with your index and middle fingers, then stuff them into your mouth, and try to safely scrub your entire mouth with soap. When you are done, rinse your mouth again and repeat this step as needed.
When drying the doll, please avoid wiping it with a towel, especially if she has a super realistic painting or smooth matte effect. A good way is to pat her with a towel until dry.
Make sure the doll’s holes are completely dry to keep up with the trend.
To dry the orifices, it is recommended to use the paper towel technique: fold several paper towels into a single or long rectangular shape, and then place the paper towel in all wet orifices. Wait a few minutes, then step on the paper towel to absorb the moisture.
After a few minutes, replace the paper towel with a new dry towel and repeat the process. Usually, it is put into the hole of the dry doll twice in a row. However, to be safe, make a third round of tissue paper so that they remain in the hole and can only be removed before sexual intercourse.
When using the paper towel technique, it is recommended to keep the doll in an upright position so that gravity can pull the water down and the brake paper towel can absorb the water.
Be very careful lest she fall. To be safe, ask her to stand in a corner of the room and tilt it back.
Other alternatives to paper towels are tampons. Simply place the tampon in the wet hole and absorb the moisture. Repeat twice, or until the removed tampon is no longer removed. prompt:
Protect her eyelashes. They are very delicate and can be replaced. If they are replaced, they can be carefully reinstalled using regular super glue.
Please don't use too much force. In particular, make sure not to apply excessive force to the area where the hand and thumb are in contact.
Do not use alcohol or products containing alcohol (perfume usually contains alcohol). Instead, choose non-alcoholic alternatives.
Well, the above nursing knowledge about silicone sex dolls hopes to be helpful to everyone. Carefully take care of your silicone doll to extend her life and bring you a better experience.
Comments will be approved before showing up.
Soak in liquid detergent and detergent for 10 minutes to see if the water has any color. In addition, you can use the split body to do the dyeing test. Generally, it will not be dyed until the water has no color. However, a new clothes should be washed so that the soaked detergent has no color. It can't be done by washing 5-6 times.
The 125cm solid doll has waist joints (can be bent forward, not backward, and can be turned left and right). The joints of the new solid doll will be tighter, and it will be fine if you run in for a period of time.
How to use the waist: press the shoulders on both sides to turn it; lay the solid doll flat, press the navel up with your foot or one hand, and then grab the shoulders and lift it up to bend.
According to reports, a sex doll shop on an e-commerce platform can sell more than 500 per day (a total of 18,000 transactions per month). Especially in the early morning, 50 can be sold, and one can be sold in about 2 minutes. In the evening The transaction volume has grown particularly rapidly.
TPE sex dolls are still the mainstream on the market, mainly because TPE is relatively low cost and feels slightly better than silicone, but it is slightly inferior in weight loss, body details and makeup coating. But recently there are rumors that Shenzhen Jingjun Doll Co., Ltd. has developed a "Thousand-faced Xiaorou" TPE doll. She solves the shortcomings of TPE dolls in terms of weight loss, body details and makeup coating. She uses high temperature resistance. The material is used as the inner liner, and the overall weight of the height of 150 is reduced to 25kg. The TPE body painting is also perfect, and the skin texture and artificial blood vessels are very realistic. If you want to know the latest developments of Shenzhen Jingjun physical dolls, you can contact them.
For many people, the first impression: beautiful, and the second impression: expensive. Yes, many people think that the physical doll looks like a real person, but even if she is beautiful, it is still very expensive. But if you have seen her production materials and her production process intuitively, you will have a deeper understanding of them.
Finally, I hope these can help you understand and choose dolls correctly.